Studio Logix Designer Online Help. Hookup Tests. Use Hookup Tests. All tests that appear on Hookup Tests. The controls on this dialog box are enabled in online mode and when the axis is Servo Off. All controls on this page appear dimmed under these conditions:. If the project is offline. If the project is online and the drive associated to the axis does not support the attribute or Hookup Test.
If you execute a Hookup test and the controller is then taken offline, the test results are cleared the next time this page is enabled online. The test results data is monitored only in the software. To access Hookup Tests,.
The default test selection depends on the Feedback configuration selected. If a test is not applicable for a configuration, the tab for that test does not display on Hookup Tests. Test Type Tab. Select the type of test you wish to perform by clicking the applicable tab. Test Distance. Enter the value that specifies the amount of position units the motor moves to perform the selected test. The default value is 1. Test Distance appears dimmed in offline mode and in online mode when the axis is Servo On.
Test Speed. Enter the Test Speed. Test Time. Enter the value in seconds to change the test time used when performing a Hookup Test. The default value is Test Distance and Test Time are mutually exclusive. The appropriate control displays depending on the Axis Configuration and Feedback Configuration. Select Start to initiate the test operation.
If the Motion Direct Command does not execute due to an error condition, an error message appears. You must tune the axis in order for the test to complete. Select Yes. Upon test completion, a confirmation appears asking to confirm the direction the axis moved. Yes - performs a set of calculations as part of the test.
